Elastic Cord – Red and Gold10” Lengths (for hangers)
Glue Gun and Glue Sticks
Scissors
Ruler
Instructions
Measure and cut two eight-inch lengths of wired ribbon for the angel’s body and two six-inch lengths of wired ribbon for the angel’s wings.
Apply a thin line of glue to the edge of each section of wired ribbon, fold in half, pinch with fingers and gather to create loops.
Turn ornament upside down and attach one large loop to the ornament cap with the glue gun.
The ornament becomes the head of the angel. Flip angel over and attach the two small loops across the back to create wings. Adhere the second large loop to the back.
Bend a six-inch length of pipe cleaner into a circle, twist to secure and bend straight piece down to create the angel’s halo. Attach to the back of the angel’s head with the glue gun and glue sticks. Tie a bow in white and gold accent ribbon and then glue to angel’s neck.
Measure and cut a ten-inch length of gold cord. Create a loop by knotting the end and then attach to the back of the angel with the glue gun.
Repeat above steps with red ornaments and ribbons. This is a fun and inexpensive craft to create in just about 15 minutes!